DO NOT plug in the "Marx" key and R Wave Trigger before software installation!

STEP 1

Install the "Intellewave" program from the CD.
Follow the Installation instructions on the screen.
After software installation you must restart the computer.

STEP 2

Connect the "Marx" key into the computer USB port.
Wait for the computer to automatically recognize and install the driver. You will see a message that the device is working properly.

STEP 3

Plug the BNC end of the signal cable into the R Wave trigger output.
Connect the female end of the signal cable to the male end of the Serial (COM) port.
For complete R Wave Trigger Setup follow the manufacturer's instructions.

The system is now ready for use.

To administer the test follow the instructions in the User's Guide.