- The Intellewave system doesn’t start and an error message appears: “Application Error”.
Install Database support updates (the latest updates from Microsoft for MDAC and MS Jet subsystems). You can find them on the Intelwave Installation CD or Microsoft web-site (for details, see topic 3, Software Installation).
- Error Message: “Protection violation: check if correct Marx protection key is plugged in”
Plug USB Marx Cryptobox into the computer (for details, see topic 3, Hardware Installation).
- The Intellewave window size is too large to fit into the screen.
Change screen resolution to 1024x768.
To do this, go to Control Panel, Display, and adjust the Screen Resolution track bar as required.
- Heart signals are not registered by the computer.
Check the connection of the input device to the computer (for details, see topic 3, Hardware Installation).
- The LED on the Cardiobelt illuminates yellow.
The Bluetooth link has not been established. Check if a Bluetooth adapter is connected to USB port of the computer.
- The LED on the Cardiobelt illuminates flashing red.
When the LED indicator illuminates flashing red, the battery needs to be charged. The CSPU has an internal battery which can only be charged when the CSPU is separated from the Belt. To remove the CSPU from the Belt, take the CardioBelt™ off of the patient. Holding the unit in your hand, depress the latch bar and slide the CSPU to the left.
When the CSPU has cleared the lock, it can be removed.
Charging unit should be connected to the CSPU and the charger should then be plugged into the electrical outlet.
The unit will begin charging. It should be charged for four hours.
When charging is complete, the CSPU can be reconnected to the Belt reversing the procedure outlined above.
A fully charged battery will provide approximately 10 hours of continuous transmission.The ability of the
battery to hold a charge will diminish with repeated charging. Cold temperature will reduce battery capacity.
